2022年11月13日 · The last setup wizard screen presented some options like "take a survey." I couldn't connect on any of them. And couldn't connect on some popular websites like Yahoo that I tried. I tried to reset the cable modem a couple times with no luck. My setup: Netgear Nighthawk cable modem ===> pFSense computer ===> desktop computer with a known good NIC.

2018年1月5日 · Hello, I followed these instructions to the letter. I have VPN up but I have horrible speeds. I have 400/40 internet service but with VPN I barely get between 20-40 Mb download. Is anyone running this setup with pfsense 2.4.3? My motherboard I'm running is Super Micro C2758 which has aes-ni capability.

2025年1月15日 · I ran into some really annoying and frustrating situations, especially with the mixed setup of multiple OpenVPN and Wireguard tunnels. Therefore I created this step-by-step guide with my major lessons learnt at the end. Maybe it's useful for some of you. This guide was created using pfSense 2.7.2-RELEASE and pfSense PLUS 24.11-RELEASE.

2024年1月25日 · Hello; I am trying to setup Pi-hole with pfSense and i have the following setup currently. Under System\General: DNS IP - Pi-Hole IP, 8.8.8.8 DNS Resolution Behavior: Use remote DNS Servers, ignore local DNS; Disable DNS Resolver; Enable DNS Forwarder - Enable Query DNS servers sequentially-- Host Overrides: I have local hosts that point to ...

2024年12月18日 · If not, I might have to just bite the bullet and reconfigure everything to connect to the WIFI on the Telstra, then setup pfSense and configure just my devices (iPhone 15 PM, Asus Zenbook and Shield TV) to connect to the ASUS in AP only mode using pfSense to do all the DHCP,DNS,NAT,port duties.

2023年5月20日 · After setting up my pfSense from scratch, I want to setup a failover WAN. My failover WAN is a router already doing PPPoE so I just need to connect it and pass thru the internet connection. 1 Reply Last reply Reply Quote 0

2019年9月9日 · set pfsense so that VLAN10 (private wifi) and LAN are in the same (private) network 192.168.10.0/24 somewhere in this forum I saw the WEBgui page Interfaces/switch/ but I don't have it! use the same DHCP server (set up in LAN interface) for private network ( …

2020年12月24日 · Moved to Untangle which has no support if IGMP, so put phones on Sonos network. Decided to give pfSense a try as a virtual machine, using version 2.4.5-p1. Turned on IGMP, moved phone to Data net, and Sonos worked like a charm. I was estatic and decided to load pfSense on hardware where Untangle had been, but I installed 2.5.0.

2023年2月22日 · Once you have gathered this information, stop the VPN client connection. For me, if I have the VPN client running, I cannot access the pfsense WebConfigurator. c. In your pfSense firewall Web Configurator, go to System > General Setup and change your DNS Servers to use one or more of these ExpressVPN DNS servers as the DNS used by the firewall.

2018年8月2日 · This is the minimal setup on the WAN side. Then i.e. with an ESXi host on the other side running a pfSense vm appliance, just route the evil 666 WAN tagged to the ESXi vSwitch and to a dedicated WAN portgroup configured to VLAN 666. The pfSense VM has two virtual interfaces, one LAN and one for WAN.