2011年4月5日 · The easiest and most common place to see new registers in a basement is the ceiling where they are tapped into the first floor duct work. Unfortunately, you also get the least benefit from heat supplied in the ceiling.

2011年1月16日 · Two 2 wire cables (4 counts) + a device (2 counts) + 1 ground = 7. Adding another 2 wire cable would take you to 9. #14 is 2 cubic inch per conductor, #12 = 2.25. Using #14 you could fit this all into a 18 cubic inch or larger box. This is assuming a single gang plastic box with no clamps.

2009年9月9日 · I want to tap into rectangular ductwork in my basement so as to get air circulating in a room I am building there. It would be so easy to cut into the side or bottom of the existing rectangular ductwork, yet all posts on the internet I have seen say cut in from the top, without explaining why.

2009年2月22日 · I am roughing in a new bathroom. i am going to tap into the 3/4" water lines (PEX) running through the ceiling. What's the best way to do this. Shut off the main, cut the PEX and drain the water, install T fitting and then turn on water once work is complete. Will this method tell me if there are any leaks in my new work.

2020年4月20日 · Here's the point at which I need to tap in. That may actually be a L/R connection there, but I can't tell from just looking at it. Unfortunately I can't simply tap off the bottom of that capped tee, as the new run of 3/4" pipe needs to basically continue off the main 1" line to be high enough to clear some stuff that's not visible in the photo.

2012年3月29日 · What is the proper way to tap into an existing circuit in the attic so I can get power to a new ceiling fan? Can someone post a diagram or a link. I also want to add via attic access 2 ceiling lights to a bedroom so I want to tap into a circuit over the bedroom.

2010年10月26日 · Hey all, I have a 2 story home with a basement. Two units. One heats/cools the second floor. One heats/cools the first floor. But the previous owner also had 1/2 of the basement completely finished, and ran off this downstairs unit for this finished room. Thermostats are on second floor...

2007年11月26日 · The other two are your black wire connections it doesn't matter which black wire or brass screw you connect your blacks from your new cables. Connect the 2 whites together in a wirenut. Some dimmers have wires to connect to and some use screws and some have a hole you connect into... don't let this confuse you.

2019年5月29日 · I'm going to use a T fitting to tap into the existing line and put a shut off valve right off the fitting. I'm planning to run 1-3 hoses off of the other end (only 1 at a time though). We are renting a trencher this weekend for the electric and I …

2019年5月16日 · I have replaced outlets, switches, fixtures, but have not added anything to existing romex. I would like to mount a tv to the wall. Stud finder showed no studs, so I opened the wall and added some. I noticed the romex and I thought before I drywall I should look into adding an outlet right...