2004年2月18日 · here's the story, the plumbers in the building maint. department say there is a clog in the 8inch pipe down the line from the discharge.well when the pump runs,after about 30mins, it heats up and the amp reading are 6.4amps on each phase. the nameplate on the motor is 9.5amps on a 480volt connection.

2016年1月20日 · 2. Using a new Excel 2016 or Excel 2013 with power query add on (free from microsoft) you can interogate the output file above using queries and some column and rows processing. The whole process is very graphic and interactive and you can do quite some smart stuff with it. (you can watch plenty of videos on youtube about power query in excel).

2007年5月7日 · Standard curves exist for control valves. You need to determine which trim exists. Some manufacturers provide tables showing the percentage travel and the valve coefficient Cv at each 10%, or each 10 degrees for rotary valves.

2001年6月9日 · Suggestions marked ///\\\: Can someone please explain the concept of phase rotation. ///It is better to refer to the phase rotation as to phase sequence since there are phase sequence meters, relays, etc. The phase "rotation" is …

2011年8月18日 · Newbe to SolidWorks 2010. I am designing a part with a slot in it. The slot is supposed to be 30mm wide and I erroneously made it 40mm wide. Using the Smart Dimension tool I want to change the dimension. However the Dimension panel shows the Primary Value dimmed out and I cannot change it. How do I change the dimensioned value of a part.

2013年1月16日 · I'm unable to change dimensions after I've created something in solid edge. For example, I drew a rectangle using the line tool, after it's been created, using smart dimensions, I'm unable to change the dimension of the rectangle. If I change the numbers in the box, it simply says dimensions...

2005年10月20日 · You could use a model dimension from a sketch. You are looking to create a foreshortened dimension. 1)Add the desired dimension to a sketch in the model.

2002年10月9日 · Thanks for the ideas guys. I didnt find the problem, although I came up with the solution. I had set the view that I wanted to put into the drawing on the part as "top", which is normal to the face with the holes on it.

2017年6月13日 · Hi everyone - long time lurker, first time poster here. I'm having some difficulty meshing an acute corner on a surface in Femap - attached is a screenshot of the meshing issue. Here is my process: - Import IGES surface - Cleanup - Mesh prep - Surface mesh I'm a novice, so any hints or tips...

2018年1月2日 · The case I'm about to present below is easily solved by having our customer update the drawing to remove any discrepancies, but sometimes that is easier said than done. Also, the drawing follows the ASME Y14.5-1994 Standard. Material is defined as Acrylic Sheet per MIL-PRF-5425. The part itself...