2011年3月22日 · The seal was there for the pumps that needed to be somewhat siliconed around the fittings that went thru the hull. This is where the neo seal came into play, to seal pump to hull. Depending on yr/mdl....the "shoe hull" was introduced, and then the "lip" of the wear ring, took the place of the neo seal, but like i said, i run those neoprenes on ...

2021年3月28日 · I ordered a neoprene seal for a 2000 GTX 155mm jet pump Part No. 293000051. I received other types of seals that look like they would work but I opted to install the older seal I had. I don't see a part number change but there is another neoprene seal Part No. 293000087 that fits 155mm seadoo pumps. Doesn't look the same but looks like it might ...

2009年7月6日 · Last year my Seadoo (95 GTX) suffered from lag out of the hole due to a missing Neoprene seal between the pump and ride shoe. I purchased and installed the seal and it was noticeably better, though still not 100% in my opinion. This year after only a few trips out to the lake, I noticed that the Seadoo was slow out of the hole again.

2020年10月2日 · I took my pump out and replaced both the wear ring and impeller, because both were bad in my 1996 GTX. I used the delrin wear ring from osd marine here: OSD Sea Doo DELRIN WEAR RING - 2 STROKE 140mm [OSD2332] - $36.99 I also bought a neoprene seal from them. I installed the wear ring with the...

2013年4月16日 · yeah, you're correct the seal from sbt is more like a cheap foam than neoprene. it was slightly smaller on the outside diameter, the adhesive side was sticky enough that i could slightly stretch the seal and place it right were it needed to be. this seal along with the small thin lip protruding from the wear ring does make a good seal. but one must make sure to step torque in at least a few ...

2016年3月26日 · The microfiche parts list does not show a neoprene seal between the two. I did pick up 2 neoprene seals but my concern is if they will compress enough for the water pick up to seal properly. The water pick up is flush with pump housing that seals with a rubber ring, not a fitting that protrudes thru the shoe/hull.

2012年3月20日 · I'm rebuilding the pump on my 92GTS, and was wondering if I need a neoprene ring for it. I did not see it in my seadoo manual, nor did I pull one off when I pulled the pump off. The pump seems to have been sealed by the wear ring lip. I have a new wear ring, and a 140mm neoprene seal, but if I don't need it, I'll just use it on my 96XP's.

2009年2月26日 · I have installed a new neoprene seal. I know I need sealant around the bailer fittings and the water line fitting that goes into the hull. Do I need to put sealant around the whole pump housing as well or just around the lines? Also, I plan on using Permatex Ultra Black High-temp RTV silicone gasket maket.

2-93200087 NEOPRENE SEAL 13.99 27.98 ... The jet pump grease seal is a 100 hr maintenance replacement item).

2020年6月14日 · The wear ring and impeller tool are the big items, but you’ll also need a new neoprene seal between the pump and the hull, a new o-ring for the pump cone, and new oil for the cone. You can use a good synthetic gear oil, the BRP pump oil, or the stuff from allots...