In Korean spec., 1-3" taller than the Mazda5, 2" wider than the '5', though the '5' is about 2" longer. (The length spec. may be misleading, for when they fit bumpers to our North American crash protection standards, the length of the Rondo will probably increase by a couple of inches).

2017年3月27日 · My 2009, four cylinder Rondo engine with 150,000 km producing ticking noise on cold start which goes away when worm up. I am not sure is this something new or always been present. Also, with worm engine I am hearing chain like lower noise. Not sure how much of chain nose is normal? Please post...

need alignment specs 2014 kia kia rondo ex EricFromCT | Kia Professional Elite, ASE A1-A9 L1 L2 Certified. 20 years dealer experience. 15,028 Satisfied Customers

Customer: I have a 2014 Kia Rondo with a 2.0L engine. The check engine light had come on and I have been experiencing rough idle, and particularly hard starting. The car has been to the dealer and the OCV replaced.

need alignment specs 2014 kia kia rondo ex EricFromCT | Kia Professional Elite, ASE A1-A9 L1 L2 Certified. 20 years dealer experience. 15,030 Satisfied Customers

I need directions on rear shock absorber replacement for a 2014 Kia Rondo 14 Kia rondo ex-fwd(2.0L) ***** Eric 20+ yrs. experience as repair shop manager and technician.

USA- 2008 Kia Rondo EXV6/5AT - - - 162539 miles Mods: K-type ATF temperature sensor, ELM327 data link, Midland 13-830 CB radio w/ Antler 38" antenna, Baofeng UV5R8W VHF/UHF radio, AstroAi ACAC8366 compressor, OEM front mud guards, LED DRL+interior lights, Audew 16800 power pack, Deep-dish rubber floor mats, AD081703GR front seat covers, AD061711B …

To remove the dome light assembly in a 2014 Kia Rondo, follow these steps:1. Locate the two small tabs at the front of the lens cover. 2. Use a small flathead screwdriver to pry down on the tabs. 3. The lens cover will pop off. 4. Locate the four screws that secure the dome light assembly to the headliner. 5. Remove the screws. 6.

2012年5月3日 · After most of my research, I'm not convinced it was the pump but we shall see. I'm replacing the serpentine belt the two idler pulleys and I have the belt tensioner which has my 17mm wrench wedged on it at the moment. If I mount the filter on the line that's on the bottom of the reservoir which direction should the flow point. 2.4l Kia rondo 09

Customer: I have a 2007 Rondo 2.7. I need the engine firing order and which bank is bank 1? I need the engine firing order and which bank is bank 1? Answered by Ron Z. in 3 mins 8 years ago