2021年5月2日 · The Burndey crimp specified D3 die, and using the Kerney crimper with the die labeled D left it loose. So I went ahead and used the O die to make the crimp tight, not closing …

2020年1月30日 · If I’m not mistaken the “BG” die is only a 5/8” round crimp ( typical for bare ground wire H tap ), and die “O” is somewhat larger for smaller H taps and “D” die works with …

2020年7月26日 · I’m looking at some battery operated crimp tools that have interchangeable heads. I’m trying to understand the differences in the heads and the information is confusing …

2023年6月12日 · I am looking at the Greenlee K425BG or K425O. The tool has D3 die grooves and either a BG or O die groove depending on model. I think I need the BG tool but I am not …

2013年3月18日 · The difference is the nose die. We use both all the time. The MD6-8 is what I would suggest if you are going to use it for secondary taps at the weatherhead only. It has the …

2020年5月16日 · It just takes a narrower die and takes four crimps vs 2 to finish the crimping the connector out. we also have a couple of 60 ton crimpers. thats expensive and used so seldom …

2021年10月16日 · Got my first crimper and was wondering if the bg crimp bay was capable of crimping a #2 alum wire in a insulated blackburn or do i need a die in the d3 …

2023年3月8日 · That example follows the style of Annex Example D3 and is for the "Demand Load" value required by 220.14(G)(2) not the branch circuit or service load @125%. The …

2006年9月11日 · 430.32 is used for sizing the motor overload protection. 430.52 is used to size the branch circuit short-circuit and ground-fault protection.

2023年2月6日 · The first use in Example D3(a) is in the sentence (regarding ampacity): "The conductors must independently ...