2009年9月1日 · As others have indicated, don't confuse the cable cutters for copper/aluminum with those intended to cut steel wire rope. In my youth, I tried to cut some bike cable with a pair of cable cutters similar to the Klein that BossHogg listed and ended up with a nice "U" shape indented in the blades and a nearly intact piece of cable.

2008年10月8日 · Blades grip cable and cut easily at center of jaws. Lock keeps handles closed for easy storage. Comfortable, plastic-coated handles for steady grip. Hardened steel, precision cutting blades for long service life. Unique triangular jaws cleanly cut cable without compression or frayed ends. Lightweight tool perfect for overhead cutting.

2009年4月16日 · I do a lot of vinyl siding and could use it at that kinda work but I think I may use the cut-off tool at other “tasks” too. At around $120 off the brand new price I think it’s a real good deal. The Dewalt service center also has a refurbished Dewalt 18v reciproccating saw at $60 off the brand new price as well.

2005年9月26日 · In the laces they placed extremely fine cable saw blades, of a style originally produced for surgeons. The blades could fairly easily cut through mild steel bars. (So, all you need to do is find a pair of WWII-era British flight boots -- with the original laces.)

2014年3月28日 · Chuck, "There's a better way" is a great video series, and this tip is no exception. However, I would like to make a contribution regarding it's name.

2004年11月7日 · I’m building some coldframes and I’ve been offerred several very large sheets of 1/4″ wire re-inforced glass. My problem is that while I’ve cut lots of regular glass, I’ve never cut the wire glass and I don’t know if it’s basically the same, or is special equipment required. Any help on this would be greatly appreciated. Thanks, Brian

2005年8月27日 · After cutting the EMT cut the wire to length, Then fold the ends over and push it down the conduit so that the loop is about an 1" below the top. Then you can either retrim it with a hacksaw or use a regular reamer.Then fish the wires back out.

2024年4月27日 · - Saw-cut 6' o/c both ways. Or 6' x 8'. Close to square is better. - Finish and CURE correctly. - After 28+ days lightly powerwash, dry, and apply a good sealer. - After 6 months clean all control joints, apply a quality joint sealant over …

2006年11月30日 · I often cut cast iron pipe with my little grinder when I'm under a house and need to tap into the drain. (don't have a chain cutter). have someone hold the shop vac to collect the dust from the cut. set new sink on top and your done. heed previous advice about supporting sink underneath first, then you can break it apart and take it out in pieces.

2006年12月23日 · 1/2 inch waterpipe supported on a 2x4 rack for a big roll of wire. There is a small one for the boxed wire. I believe it hangs on a vertical stud allowing you an easier pull. I Will have to look to find the brand. I think it was an independant mfgr. There are bigger welded devices that commonly exist and are sold by Gardner Bender and Greenlee.