2007年2月18日 · The oiiling system need not be changed since both Evo and Shovelhead lifters pump up through the lifter blocks in the same manner. The Shovelhead already oils the heads through the rocker arms up top and the oil goes back down the cylinder and or tubes. No oil need be sent up through the pushrods in any case,

lifters 12-02-2017, 09:21 AM When installing hydraulic lifter tappets into the lifter blocks the book says to install tappet body's so holes in tappet body face each other.

2009年2月22日 · I took a hdy lifter shovel to solid using the inserts (S&S) I didnt plug anyting and ran the BH grind cam. it ran fine . well this was a solid lifter motor stock and I put in hdy. bent a couple valves and then put the inserts in the hdy lifters.they were a little noisey but they all were LOL I beat the piss out of it .

2007年8月14日 · I just finished with the top end rebuild of my 83 shovelhead. installed a b grind cam, rebuilt the heads and rocker boxes, new tappets w/solid lifters and 40 over pistons. Have Pro-clutch as well. The bike runs good has good power when cold,front end comes up acouple inches shifting 4 grand into 2nd gear. What I have expected.

2015年11月28日 · They are unreliable and noisy. Your lifters look rough as well as the tappet, block. Real solids do not have a flat with an oil feed hole, they fill with oil, bad for conversions. Use 10-32 set screws and red loctite to block the oil passages in the tappet blocks. Drain those lifters, and seal the holes. Or replace all them with real solid lifters.

2007年7月31日 · I purchased a set of Crane lifters for my panhead and the instructions that came with them are, in fact, different than the "normal" adjustment procedure. The commonly accepted method of adjusting hydraulics is to extend the pushrod until you just barely make contact with the lifter (zero lash), and then extend the pushrod another .100 - .125 ...

2010年7月24日 · I have an 81 Shovelhead with stock hydralic lifters. I did a recent rebuild and did the drie lifter adjustment. After worm-up I have a ticking lifter at idle. I've been told to trie a heavier weight oil and I can also do a 1/4 turn adjustment to my pushrod length.

2015年4月30日 · :stir2:the S&S heads are good out of the box,they have smaller ports for higher velocity, and considerably better flow than stock heads.A 4 3/4 stroke with 31/2 bore is 91 cuin and is a great combo with the right cam and exhaust,and there is no case boring.Leineweber L3S cam and velvet touch lifters you have a fast and quiet shovelhead!

2004年9月9日 · Q: Like I said in the original post, there was a top-end rebuild about 2000 miles ago, so everything should be in great shape, I just want to attack this clacking without having to pull the pushrods, lifters, tappets, etc. ===== A: You must empty the lifters first in order to adjust the pushrods correctly.

2020年4月9日 · Buy STEEL Roller Lifter Set USA-Made Hylift-Johnson compatible with 1984-98 Harley EVO 1340 Big Twin SLOW LEAK (Slow Leak Lifter): Lifters - Amazon.com FREE DELIVERY possible on eligible purchases