2021年9月12日 · Then I used a b550 elite 1.1 update which made the qflash plus button flash quickly for a minute but then turn off. FINALLY, I found that mine was an AX (wifi). So I found the right one and boom, light flashed quickly for a minute, then slow flashing for about 10 (computer fans actually turned on).

2021年11月6日 · Don't press the power button, make sure the motherboard is in standby (S5), then hold the qflash button until the qflash led starts to blink. Then wait until the motherboard goes back to standby by itself. It may take a couple minutes. Also make sure the flash drive is inserted in the correct usb port, refer to the motherboard manual.

2020年11月10日 · Then after 30 seconds i pressed the Qflash plus button and YES! the color led near the qflash button start blinking. Left it there for 30 minutes (i think though the firmware update took about 5 minutes and then the system did shutdown automaticly). then switched off power and removed power cord.

2020年12月8日 · I formatted my 32gb flash drive with FAT32. It worked from within the BIOS's qflash. It did not work with the qflash+ (plug in USB drive into empty motherboard and press the qflash+ button). FAT32 has a maximum partition size of 2TB.

2022年11月27日 · Powered on the PSU and clicked the Qflash plus button. lights started blinking. went out for a walk that lasted me about half an hour (it probably takes shorter amount of time, but I just went for a walk to avoid any temptations to mess around with it. :D ) came back and it was done. no more lights blinking. put in my CPU and it worked.

2021年2月24日 · Planning on building a computer but need some advice? This is the place to ask! /r/buildapc is a community-driven subreddit dedicated to custom PC assembly.

2022年9月14日 · If you look at the CPU support table for your m/b it supports 5900x from F2 as its a fairly new motherboard type - i.e. there is no need to waste time with QFLASH+ - it should POST to BIOS from where you can use normal QFLASH to update to latest

2021年12月28日 · Make sure the flash drive is fat 32 and is connected in the appropriate usb port, hold the qflash plus button until the qflash led starts blink then wait until the motherboard go back to standby by itself, it may take several minutes. After this it will boot to the backup bios and flash main bios by itself.

2020年11月20日 · I turned the psu on then pressed the qflash button once then the fans spinned and the led started flashing IT WAS UPDATING! At this point I knew it was gonna work. After it updated the mobo shut down then I waited 2 min to turn off the psu and reinstall the cpu and it booted with our new hardware. Tldr: look at the tutorial section.

2024年1月7日 · Thanks, renamed it. Left it as only file. Pressed physical white Qflash button on MoBo. It reads USB stick (stick LED blinks) but LED on MoBo doesn't start blinking and it doesn't start the update process. Also USB led indicates mobo isn't reading anything after first check of what's in there. It doesn't accept it...