If the rocker shaft is damaged or broken, it may be replaced at the Fleetari Repair Shop. Visually, a broken rocker shaft will be slightly bent and some of the valve springs will be gone, as well as all of the valve adjustment screws.

Jun 4, 2017 · Rocker shaft problems now are VERY likely caused by an inability to read the changelog that clearly states that engines need to be timed. Set my valves and cam timing correcting three times now and the engine breaks the rocker shaft on each startup.

Apr 3, 2019 · Look at the camshaft gear, there should be a marking on it. This should align with markings on the engine block and crankshaft. If it does not, tighten the bolt. It will rotate the gear. Rotate until they are lined up. Put everything back together and replace your rocker shaft.

Mar 27, 2018 · I have bought a couple new ones, and repaired the rocker shaft in MSCEditor and it breaks again when I start it - the car runs for about a second or two and then dies

I have adjusted and correctly tuned the camshaft, aligning both markers together, I have tuned the rocker shaft itself, screw all the way down and 7 up, and I've tuned the distributor, setting the bolt just to the right of the centre.

A) The rocker shaft and/or carburator and/or distributor are not tuned properly. They do not make any noise when the car is running (apart from the rocker shaft if it was tuned prior to starting the car); they are also the most difficult car parts to tune correctly.

Apr 15, 2022 · AFIK the rocker only breaks abnormally if the tuning is off. Do you hear a rhythmic clicking noise while the engine is running? Also are you fixing it by replacing it at Fleetari or just loading a save when it breaks? It could just be low durability. All parts wear over time if …

Jul 26, 2023 · If it’s worn it’s fine, if broken then the car won’t run. The trick to reach 200kph is to mount the rally tyres on, because they are a bit taller then the other tyres and give you a tiny bit more speed, just enough to get over 200

Dec 12, 2017 · I already asked this question in experimental but im going to ask again. I bought a new rocker shaft from Fleetari because the last one broke Whic I Assumed was because of have a low condition. However my replacement just broke. How am I putting excessive wear on the rocker shaft? How do I fix this?

Jan 8, 2024 · just finished first build. and when i try to start the car a few bangs go by and the rockershaft breaks. i find out that the camshaft isn't aligned, so i fix that and start it again. the …