If the LEDs are still blinking red: Take the hearing aids out of the charger and disconnect the charger from the power supply. Contact your Hearing Care Specialist for support. Consult your Hearing Care Specialist if you encounter further problems. Important safety information General warnings Observe the operating conditions. Refer to the section

Charging status of the hearing aid is displayed before charging starts. Hearing aid is fully charged. Charging is resumed after 5 minutes. Flashing red LEDs: Error Read more in section “Troubleshooting”. You may have some questions on how to best charge your hearing aids. Read the questions and answers below.

Page 25 Problem and possible solutions LEDs are flashing red alternately. An error in the charger has occurred. Take the hearing aids out of the charger and disconnect the charger from the power supply. Reconnect the charger to the power supply and …

Troubleshooting for the charger Problem and possible solutions Charger LED is blinking red. Problem and possible solutions An error in the charger has occured. No LED lights are on. Take the hearing aids out of the charger and Check if the power supply is connected correctly.

NOTICE LED light is blinking red 3 times: An error in the Risk of injuries caused by electric shock! charger has occurred. Important safety information If the LEDs are still blinking red: Take the hearing aids out of the charger and disconnect the charger from the power supply.

The Miracle-EarCHARGE™ fullpower RIC/BTE T AV charger is designed to be a pocketable charging option for lithium-ion rechargeable RIC (Receiver-In-The-Canal) or BTE (Behind-The- Ear) hearing aid (s). The charger works when plugged into a wall, or on-the-go with an onboard battery that will recharge a pair of hearing aids up to four times.

LED lights are blinking red 3 times every 2 sec. or LED lights are blinking red in a sequence An error in the hearing aid or in the charger has occurred. Take the hearing aids out of the charger and disconnect the charger from the power supply. Reconnect the charger to the power supply and re-insert the hearing aids in the charging slots.

The charger is intended to charge Miracle-Ear® specific hearing aids with built-in power cells (lithium-ion rechargeable batteries). Use the hearing aids and accessories only as described in the

– Blinking Red = Fault State. To reset, remove the hearing aids earbuds/earmolds resting in the reservoir from charger, wait until LED turns off and re-insert aids. If Fault State continues, call your Miracle-Ear Hearing Care ® • Your hearing aids will …

2023年10月12日 · Red means you didn’t insert the hearing aid into the charger all the way and it didn’t charge properly. Make sure the wires are not crossing each other in the charger well or one of the hearing aids might not be all the way into the charger.