2015年4月30日 · ifconfig. ifconfig -l will list just the names. So nice, and rare, not to need to text-mangle results. ifconfig -v [ifname] shows more verbose information under the type: key. It's also pretty cool to see the scheduler (e.g. FQ_CODEL), low power mode, QoS marking, neighbor discovery settings (for IPv6).

2011年5月18日 · Honestly, your best bet, rather than wasting your time obtaining and reading 100x over-complicated legacy sources of ifconfig, etc., is to just run strace ifconfig ... and look at what ioctl syscalls it's making. Actually, this is a great general approach to replicating behavior from programs which have overly complicated source logic or for ...

See "Replacing ifconfig with ip" it is most often recommended to move forward with the command that has replaced ifconfig. That command is ip, and it does a great job of stepping in for the out-of-date ifconfig. But as seen in "Getting a Docker container's IP address from the host", using docker inspect can be more useful depending on your use ...

ifconfig eth0 | grep HWaddr or. ifconfig eth0 |grep HWaddr This will pull just the MAC address and nothing else. You can change your MAC address to whatever you want: ifconfig eth0 down, ifconfig eth0 hw ether (new MAC address), ifconfig eth0 up

2011年12月16日 · We can simply use only 2 commands ( ifconfig + awk ) to get just the IP (v4) we want like so: On Linux, assuming to get IP address from eth0 interface, run the following command: /sbin/ifconfig eth0 | awk '/inet addr/{print substr($2,6)}' On OSX, assumming to get IP adddress from en0 interface, run the following command:

2012年7月14日 · Given this specific line pulled from ifconfig, in my case: inet 192.168.2.13 netmask 0xffffff00 broadcast 192.168.2.255 How could one extract the 192.168.2.13 part (the local IP address), presuma...

2010年7月22日 · In an effort to narrow down the issue try the following: - open command prompt - make sure you are on the C:\> directory

2024年12月10日 · How can I use ifconfig to show active interface(s) only and display interface name, MAC address & IP ...

2012年7月26日 · my ifconfig output is different inet addr:192.168.210.140 Bcast:192.168.215.255 Mask:255.255.248.0 inet6 addr: fe80::92fb:a6ff:fe66:970/64 Scope:Link however the difference is not great u will find out what u need to change (I understand u need to check one interface - here eth0; every interface has one inet line)

2012年10月5日 · hmm, not on my flavor of ifconfig. asker should have posted the ifconfig -a output in the question, this seems to vary quite a bit from system to system. really should be grabbing this info from /sys/class/net or /proc/net/dev anyway. –