2025年3月21日 · HyperScale X scale-out software provides for the creation of a storage pool for housing protected data. The initial creation of a storage pool, requires 3 similarly configured nodes. Expansion of the pool can be accomplished through the …

To maintain data integrity and to prevent data loss, it is important to follow the proper shut down and startup procedures outlined in this page, while stopping or starting a node. Use the steps outlined in this page to shutdown and restart a single node, for maintenance purposes.

2024年12月3日 · Commvault HyperScale X nodes can be deployed with a basic data protection and storage pool interfaces. Use this procedure to deploy the Commvault HyperScale X software using the Hyperscale ISO 3.2312 or higher version.

2024年11月15日 · Adding a HSX 3.x node to an existing 2.x cluster is supported. Commserve will need to be at Commvault Platform Release 2023E or higher. Prior to adding the node(s), the existing 2.x cluster must be on platform version 2.2312 or higher.

This guide contains the HPE Complete Assured solutions for Commvault HyperScale X on HPE ProLiant DL360 Gen10, HPE ProLiant DL380 Gen10 Plus, HPE ProLiant DL380 Gen11, and HPE Apollo 4200 Gen10 Plus platforms.

Use the cluster name to start the node using the following command: # /opt/hedvig/bin/hv_deploy --start_node <fqdn hostname> --cluster_name <Clustername>

2025年3月21日 · To maintain data integrity and to prevent data loss, it is important to follow the proper shut down and startup procedures outlined in this page, while stopping or starting a node. Use the steps outlined in this page to shutdown and …

2024年12月20日 · HyperScale X Appliance nodes can be deployed with a basic data protection and storage pool interfaces. Verify the requirements needed for setting up the Basic Topology in your environment. Keep the network names and IP addresses listed in the Network Requirements section of Basic Topology handy before you start the configuration.

2023年8月29日 · Is it possible for me to include this server in my HSX environment if the next-generation reference architecture is released and I need to add one node to my existing platform? Best Regards

2023年5月24日 · The nodes at this point do not need to communicate. Once this step is done, you can then issue the hsxsetup command and assuming all the network pre-work is done this is when the nodes will discover each other. https://documentation.commvault.com/v11/essential/153848_setting_up_network_in_hyperscale_x_reference_architecture_nodes.html