2005年11月30日 · Looking at the Dolmar ps-401 for light limbing and small brush cutting. The specs look pretty good, however the saw "looks" completely different than their mid size saws. Has anyone here used this saw? Does it have a good reputation like Dolmar's bigger ones? Are the listed specs accurate? PS-401 2.27bHP 8.6lbs $249.95 16"

2013年4月24日 · This Dolmar/Makita family, the 6000 and 6800 were a 1997 remake of the old favorite Dolmar 116S & 120S as they use the same cylinder and piston. Parts have become rather scarce from Dolmar for these since the first of the year.

2010年1月27日 · Dolmar saw the problem, and it was us: dealers and users! Dolmar warranty people say set carb up right and maintain it well (synthetic oil, clean saw and sharp chain) = few problems. In addition, while they won't say it publicly, Tru South's synthetic/89 octane gas mix or Avgas will avoid ethanol issues and is better than mogas with stabilizer!

2008年2月7日 · Dolmar has used the 64 driver count for years and years since 79' when I started and probably even before at that time windsor used the CJL mount which was 64 driver. Oregon then had if available in the AO95 mount then the 262Husky came along and I guess they whined enough to Oregon to get the AO95 mount adapted to a KO95 mount and then ...

2007年7月28日 · The weight—according to Dolmar is 13.9 pounds, and that’s probably about right. It outweighs my 2171 by about half a pound, and the difference is noticeable but not nasty. The 2171 is nicer to run because it’s lighter and smoother, but doesn’t come close to …

2006年10月26日 · Saw seems built well. Great power band. I hate to tell ya, the 5100 would eat up a little 346XP w/out a question. I know because I tried one out about 2 weeks ago. It's not even close. The torque and general feel of the 5100 is much more pleasant. I said it before, I'll say it again. Dolmar is the best combination of the best saws out there.

2002年3月26日 · Only later Dolmar its prominent market position with still lighter, handy models developed few years. Owing to the strongly growing demand Dolmar referred 1969 a new factory at the current location in Hamburg Wandsbek. Reduced 1972 imported 2-Massen-Vibrationsdaempfungssystem von Dolmar noticeably the physical load of the users of petrol …

2010年4月25日 · Dolmar-No Support After 30 years my Sachs-Dolmar 118 gave out, and I contacted 4 eastern Mass. "dealers" listed on the Dolmar website to try to get a Dolmar 5105. Three said that even though they're listed as dealers, they don't stock (or even show any willingness to order) Dolmar saws because of lack of support.

2016年8月4日 · fairly rare... Dolmar made the 152/153 and they don't share parts with any other saws except the Poulan 5500 and 6000 (dolmar built Poulans). I will say they are extreamly hard to get parts for but if it runs and cuts I would definitely pick it up for $250. Keep in mind that price is cheap for a 100cc saw.

2014年10月24日 · But when you use a 120 Super or 6800i in the woods, they don't need any change. The porting is old school as the transfers are all in the cylinder wall with a windowed piston. I ran it against a older Echo around 68cc and the Dolmar carried a lot more RPM but the Echo had a 8 pin rim so the cut time was real close. The Echo was much heavier.