2010年12月18日 · Best Turbo Upgrade For 02 Wrx Newbies & FAQs. when i had my 05 wrx i went stage 1, then got my downpipe etc... and had stage 2 for quite a while then i got a vf34...turned out it was bad finished with the very similar vf48. in all honesty in terms of usable power and just a good car...the stage 2 was my favorite. it wasn't as fast up top but it was a lot less to worry about aka didn't have to ...

2013年3月10日 · Well, i found the part # for 02 alternator belt....809218270. And from what I found out, that size is the 350. And i know both of you recommended the 345, but I bought 2 different 345 from advance auto (dayco and drive-rite) and I can't get them on...probably about 1/4" short of the alternator pulley.

2008年4月24日 · So 10,000 miles ago I put a 06 wrx transmission into my 02 wrx. I read it was pretty much a straight swap just clutch, slave cylinder, slave cylinder line, and front cv’s. Now I’m thinking it wasn’t that simple. When I did the swap I kept the 02 wrx rear diff and mated it …

2014年7月8日 · 02 WRX Fuel Line Routing Built Motor Discussion. I have searched the forums and looked over the "Fuel line routing (with pictures and arrows)" but nobody covers exactly what im looking for.

2016年3月16日 · Need '02 WRX altinator Pulley: Mighty Subie: Private 'Wanted' Classifieds: 10: 03-28-2006 01:03 AM: Boost surging, help needed! corey_dyck: Factory 2.0L Turbo Powertrain (EJ Series Factory 2.0L Turbo) 11: 11-14-2005 10:38 PM: Any known surging problem on '02 WRX? JonnySubaru: Factory 2.0L Turbo Powertrain (EJ Series Factory 2.0L Turbo) 7: 10-17 ...

2010年7月13日 · the 02 wrx, IIRC, doesn't start spooling until ~3000 RPM... so if you're anything below this range from 2nd gear and up, it's going to feel sluggish. turbo motors have a lower compression ratio so they feel much less responsive in off-boost conditions compared to N/A motors such as the 2.5 RS and the 03 legacy that you mentioned.

2015年5月11日 · Background: My 02 WRX had at least two leaks under the hood. I could smell the coolant leak, and I could hear a vacuum leak (which also made my heater lose heat at idle). Knowing the car is now 12 years old, I decided to go through and replace all of the hoses and hope I remedied the two issues.

2010年4月3日 · The 2002 WRX uses shim-over-bucket. These valve clearances can be checked and adjusted with with the engine in the car. Its best to use the Subaru/SPX special tool if you need to replace shims.

2012年2月5日 · This is a ROM developed to enhance the capability of the stock ECU on 16bit Subarus. It uses a Speed Density control scheme which means fueling is calculated primarily from the MAP sensor instead of the MAF sensor. As it is based off the Group-N ROM it will only work on 02-03 USDM WRX ECUs and 02-04 JDM ECUs.

2016年3月14日 · Which on a 2008 wrx(and several years higher, along with the Sti) Is on the second ecu wire connector plug, counting from the left, its the top row of wires, 4 over-again counting from the left. The Cobb "flexfuel" has the ability to use this input to the ECU and you can "scale" it to match the Widebands voltages.