2006年4月12日 · I called every distributor in my area and discovered it was called Tectum Decking, most had heard of it but none had it in stock. They knew of one guy that could get it and he said there was a 9 piece minimum and cost was $1,100. Panel size (30"x83"x3") Also it would take 1 week to get the stuff. This panel served as the Deck, Insulation, and ...

2014年4月28日 · Its called "Tectum" or so I'm told. This is the roof deck AND the ceiling. ... to attach the roof ...

2004年1月14日 · The last roof deck I did was over a torch down roof. I set strips set sleepers on as a double layer. screwed 5/4 timber tech to the sleepers. This was done as a change order and when I got to the county to revise the permit they gave me a really hard time about uplift on the deck as it floated. even there was only a 1 1/2" gap at the lower end ...

2024年2月25日 · I built a 18ft wide x 10ft off the house deck. Deck has double 2x10 rim joist with 2x8 joist 16in on center with 4 6x6 post that are notched and have 14in footings. I built this deck with a shed roof design in mind, but I mocked up the shed roof and not a fan of the look so I’m trying to switch to a gable roof to match the home.

2011年5月18日 · If you spray the roof deck you are now adding that CF to the air you are heating and cooling, with some lower pitch roofs that is fine (the one we did that way was a 4/12 with little attic place or access, so it worked great), if you have a 10/12 I would rather spray the ceiling deck to seal out air and then place some blown insulation on top ...

2005年11月5日 · under the membrane is 3/4" foam.The outside walls are 8" block.capped with 2x's. The joists need to be run across the 'ridge' 24' span end to end.

2024年4月5日 · Looking to find max spans and spacings for 4x6 SYP #2 rafters for a lean-to roof over deck. The 4/12 pitch roof will help determine deck size. The T+G will be 2x8 SYP as well. Hoping to space up to 48"oc but 32"oc would also be ok. Located in central WI where i have a 40psf live and 10psf dead loads with a 240 deflection.

2009年4月25日 · Existing deck is 24 w x 10' deep, ledgered to house, rear beam is 8' back (so there's a 24" cantilever). 2x8 joists 16" oc, dbl 2x10 rear beam. 5/4 decking. To convert the deck to a porch I need to load the roof onto the deck's cantilever (code problem). Do I have to reframe this deck to make things work? Thanks.

2008年8月18日 · under deck roof Jump to Latest 67K views 20 replies 12 participants last post by BuiltByMAC Jul 3, 2009

2013年1月27日 · The township uses the IRC codes and I have been able to design the deck so far, but now that I am adding the roof I cannot find the information. The deck Floor will be 14' off of the ground and is supported by 6x6 posts. The Homeowner would like to have these posts extend to the roof, but I don't know how easy it will be to find 22 foot 6x6.