2005年11月2日 · In the last week or so I’ve noticed a new plywood product at the Home Depot – Sandeply – it’s 9 plys, 3/4″ thick, triple sanded and said to be good for painting and staining. It only costs $29 a sheet, that’s pretty nice compared to the $45 I’m paying for Birch ply now! Question is, anybody using this stuff?

2006年7月14日 · sandeply= 1/2" ACX fir plywood? I use 1/4" Baltic birch ply for drawer bottoms pretty often, unless the drawer is more than 16" wide. Birch ply is very strong for it's thickness, and it's very consistent, with no voids or knots. I recommend it. Plus, 1/4" …

2005年2月9日 · Sande plywood can be used for finished cabinets, although it can be tricky to stain and top coat. A wash coat of sealer thinned about one part sealer to 4 parts solvent applied to the surface, allowed to dry completely, then thoroughly sanded …

2016年3月21日 · "Sande" does not mean that the wood was sanded. Sande is a species of wood and lumber from Central America. I have bought some usable Sande plywood from HD but the exterior is extremely thin and prone to splintering. You are always taking a risk. The external appearance may be good but the interior plies just trash.

2015年2月3日 · HD plywood is often "trashed" here and for good reason. Not this time I am building a 60" floating vanity and needed some carcase plywood. Home Depot had a lumber core 3/4" plywood. It was three ply with a surface veneer of about 1/16" covering the lumber core on each side. I bought two sheets and I was very pleased.

2010年7月6日 · I used the small kreg jig jr. in walnut that was planed down to just a hair under a half inch. It did fine, but I used the pan head screws....and they have a thicker head, which that added with the fact the kreg jig can not compensate for under thickness with the drilling guide, I had maybe a 1/32" or a bit more of the screw head sticking out the edge of the hole, and the …

2010年12月23日 · I'm getting ready to build some cabinets and book cases from birch plywood. I'll be painting them white. One suggestion I heard from a coworker is to brush a thin layer of urethane on the bare plywood and then sand it before priming and painting. This is supposed to keep those little wood fibers from sticking up through the paint.

2018年1月5日 · I know no one's shocked, however what they have sometimes works for me to make "acceptable" cabinets for my house.

2019年7月20日 · If you go to my post “I now get paid to play with tools...” I’m building 56 arched doors. I cut the arch on the bandsaw with a simple jig- plywood with a screw at the pivot point. It helps to have a massive 3-phase bandsaw with insane inertia that plows through anything. It takes literally less than a minute per arch.

2018年12月31日 · I am about to start a built-in project for my home office and will need to make some paint-grade bookshelves about 30 inches wide and 5 feet tall. I went to HomeDepot looking for 3/4 birch plywood and they were completely out. They did have a huge stack of "radiata pine plywood" which looked pretty good and had 9 cores which appeared void-free.